Sample and Hold, Internal Clock, Analog Switch and Amplifiers Done
Earlier this week I've finished the Sample&Hold, Internal Clock and Analog Switch part:
The 1.5µF electrolytic capacitor (bright blue) at the bottom wasn't available with Mouser, but luckily I had a few of these from the past. Then I had made a little mistake: Soldered in a 10Ω resistor instead of a 100Ω one (near the 1.5µF capacitor, in vertical position). I only noticed when a 10Ω resistor was missing for the next section, the amplifiers part. Removing the vertically positioned resistor and putting back in the correct one was not that easy.
[Update] Then only later I detected that the analog switch was not working correctly. Channel A was always on. I had overlooked to solder one side of a 3.3MΩ resistor that controls one of the 2N5172 transistors, which actually can be clearly seen in the top-left corner of the above image. The fix was thus easy, luckily.
And thus also the amplifiers part was finished:
|
|